• A SNMP agent for ComAp NT line controllers
• Connected to the controllers via RS485 (Modbus)
• Up to 32 controllers served by one device
• Provides access to basic operational and statistic values (not configurable) using GET transaction
• Generates a TRAP event if any protection occurs in the controller
• Mode change and basic genset control is also available via SET transaction

Used for CAN bus extension in cases where the maximum distance limit would be exceeded.

• Intercontroller CAN bus extension (one or more I-CR modules can be used)
• Intercontroller CAN bus bus-tie bridging - makes groups of controllers in segments A and B "invisible" one for another depending on bus-tie breaker state, keeping the PC communication (IG-MU, IG-IB) in function for all controllers
• Peripheral CAN bus extension

• Using Internet Bridge you can easily service and monitor your gen-set even from the other side of earth
• Enables internet connection between controllers (IGS-NT, InteliGen, InteliSys, InteliDrive) and superior service or monitoring software (GenConfig, InteliMonitor, InteliSupervisor, IGS-LOG, WinEdit, MultiEdit, DriveConfig or DriveMonitor)
• Ethernet or dial-up connection of the controller to the internet
• Supports single/multiple gen-set control via Internet
• Sends active e-mails in case of alarm on site
• For more gen-sets additional hardware key (IG-IB3, IG-IB7, IG-IB15, IG-IB32) is required
• UL certified

• Direct or modem control of multiple gen-sets
• RS422/RS485/ModBus support for direct connection
• Analog/GSM/ISDN modem support
• Modem callback function
• UL certified

• Bridge for sites with multiple controllers for local or remote monitoring and control
• Direct, modem or USB (I-LB+ version only) connection to multiple controllers
• RS232 / RS485 / ModBus support for direct connection
• Communication speed up to 57600 bps (including ModBus mode)
• Analog / GSM / ISDN / CDMA modem support